I'm just wondering what other users set this value to, as it's configurable from 1-251mW. It has increased the signal on my wifi devices slightly over the stock Cisco firmware. The TX rate on the wireless status page is showing as 71mW (default). Anyone exprience this as well? Not a biggie but just curious.Ģ. The wi-fi protected setup LED button on the router is yellow/orange after the install. I have a couple of questions/concerns after the install.ġ. I've installed the dd-wrt.v24-19342_NEWD-2_K2.6_mini_m10.bin (Brainslayer) as per the instructions in the forum. other things to check is make sure your wireless security is WAP2-AES, cuz n wont work with other securty protocols in dd-wrt from what ive read. but either way if your using a device that is only g rated the router will always revert back to g, to get the full n rating you will have to use a device that is also rated n. You can try and set the wireless mode from mixed to g and n, or just n. Was gonna use WDS to link 2 of them together but its a waste to only be able to link over G. Has anyone gotten wireless N to work? All I have is wl0 running DD-WRT v24-sp2 (04/07/12) mini - build 18946M NEWD-2 K2.6 Eko. Do that, and using it as a client bridge works well. The main point is making sure that your wireless security settings are the same. Getting it to work as a wireless extender for my main router was a headache. I used the dd-wrt.v24-18024_NEWD-2_K2.6_mini_m10.bin on my valet M10 and it upgraded beautifully. Please would like to hear any do's and dont's What firmware version is best for using with wds, i have a two router setup in my home using wds and my m10 router keeps losing connection every couple hours. here is the modified firmware to reflash an m10 v1 from tomato back to the latest stock firmware, i flashed with this and was then able to flash back to dd-wrt,just put the attached file into the upgrade section of tomato UI, there is no need to change file extension or anything, Or a version of ddwrt firmware that has the valid header so I can download. The know how to modify the header on the ddwrt firmware so I can update then reflash. Stock firmware (v1 that I can download that will enable me to flash back without having the file invalid header error (the one on the Linksys site has v2 firmware and I assume I don't want to go to that version as it will no longer be flash able?) I have read that I need to modify then binary header but am unsure how to do that or what software to use. The problem is when I try and flash the ddwrt firmware I get an error file has invalid header. I had some success using ddwt so want to revert back. I have switched from ddwrt to tomato but am having no success getting it to extend my wireless network. Posted: Tue 6:04 Post subject: modified m10 stock firmware

Cisco valet am10 software download